After installing the EVO ONE on a 2014 Ford Expedition, during the programming I put in the first key and turn the ignition on and get a red blink and yellow light and turn the ignition off. I then put in the second key and turn on and get a single red blink and turn the key off. I then press the programming button within the 5 second limit and get a single red flash and then the red stays solid. I have rechecked the wiring and confirmed it to be the same as was shown on wirecolor.com as that is different than what is shown on the install guide on your site. I was never able to find the BCM on the driver side or locate the 13 pin or 26 pin connectors that were supposed to be located on the BCM on the driver's side of the vehicle. Can you please help me on what could be the issue during programming?
Thanks,
Jason
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
